How i did mine…half way there
Posted: Tue Apr 24, 2012 8:14 am
Take a set of idle adjusters from some unknown Honda carbs 
Reduce the end to accept a 2mm die, drill a corresponding hole in the fuel metering needle, tap a clean thread (forget to take photo
)
Clean and then re-plate all parts, looks beautiful
Assemble using an epoxy two part adhesive as a thread locker
Install using the original idle adjustment bolt and marvel at the factory look…and it works!!
Not quite….first correctly assemble the carb boots, as they were both upside down and the clamps back to front making it a real bitch to get off, numpties have been here
Part two comming
Reduce the end to accept a 2mm die, drill a corresponding hole in the fuel metering needle, tap a clean thread (forget to take photo
)Clean and then re-plate all parts, looks beautiful
Assemble using an epoxy two part adhesive as a thread locker
Install using the original idle adjustment bolt and marvel at the factory look…and it works!!
Not quite….first correctly assemble the carb boots, as they were both upside down and the clamps back to front making it a real bitch to get off, numpties have been here
Part two comming
