bent tab ?
Moderators: trixynut, Mincehead, dicky, phuk72, Jak, Kevtrx849
-
trxster
- TRX-Enthusiast
- Posts: 77
- Joined: Fri Jun 06, 2008 12:07 pm
- Location: Eagle Heights, Tamborine Mtn. Queensland
bent tab ?
The tab that is used to bolt the steel water pipe into the top of the cylinder head, is the tab straight and flat ? or does it kink down toward the O ring approx 2mm then out at 90o ?
-
trxster
- TRX-Enthusiast
- Posts: 77
- Joined: Fri Jun 06, 2008 12:07 pm
- Location: Eagle Heights, Tamborine Mtn. Queensland
Re: bent tab ?
I should have looked a bit harder, in "Tech Tips", photos and all ! 