charging issues

roareruk · Post by **roareruk** » Wed Jul 25, 2012 9:22 pm

hello ive had a few issues with my trx .... it was boiling the batterys dry last time i had it out .... so i bought a new battery charged it up with optimate ... put it on the bike and fitted a new rectifier ... regulator ... tested for charge voltage and it isnt charging i put the old rectifier back on and its the same it isnt charging .... tested at battery and tested between the 3 white wires to check for voltage coming from generator ... altenator and it was as 4v - or + .5v .... ive ordered a new generator ... but noticed the rectifier was getting hot and also the 3 white wires coming from the generator where getting hot too ...... am i barking up the wrong tree here not new to swinging spanners but new to swinging spanners round bikes

cheers in advance guys and gals waiting in anticipation of your replys .... thasnks again H

oh trx is pretty standard 96 n stage 2 dyno k&n stubby microns braided lines is about it ..... one for seal is weeping so thinking about changing front end with alot of other bits and bobs

Post by **Mincehead** » Wed Jul 25, 2012 10:22 pm

Genrators do go on TRX`s, no more so than any other bike though. I had to put a new one of mine after it died on me.
There is a resistance test you should carry out between the three wires from the generator, you`ll find the values in Mr Haynes bible or perhaps in the downloads section on here, look under the repair / service pdf.

roareruk · Post by **roareruk** » Wed Jul 25, 2012 10:37 pm

apparently the volt when running between any two of the 3 wires can be between 14 and 40 v .... mine was a measly 4 + or - .5 will let you know how things come along and get some pics up .... low milage too 19k from new not bad for a 16 yr old trx

roareruk · Post by **roareruk** » Sat Jul 28, 2012 5:54 pm

generator / alternator replaced and now getting a nice charge rate lets hope the replacement rectifier works too

roareruk · Post by **roareruk** » Sun Jul 29, 2012 10:22 pm

hold the fort ...... charge voltage dropped off ...... turns out it was a short in the connector .... so bad its melted the housing .... tried to source one but can only get the male part of the connector ..... nows a decent time to buy myself another trx .... one to tinker with

Post by **Mincehead** » Mon Jul 30, 2012 7:45 am

What connector, the white three pin one from the alternator / generator?

roareruk · Post by **roareruk** » Mon Jul 30, 2012 5:33 pm

yeah its 5 pin red black and 3 whites .... the melted part is on the harness side ..... the rectifier did need replaced feel i may have replaced a generator that didnt need it lol but spares is a good thing

Yamaha TRX850 Enthusiasts Forum

charging issues

charging issues

Re: charging issues

Re: charging issues

Re: charging issues

Re: charging issues

Re: charging issues

Re: charging issues