Page 1 of 1
Not starting after changing emulsion tubes
Posted: Wed Jan 25, 2017 5:52 pm
by Crazluke
Hello was wondering if anyone could tell me what the problem might be I changed emulsion tubes two days ago and I havnt been able to get the bike started ive had the carbs apart multiple tines checking and everything seems fine ive checked the piping that seems to be fine too I just can't get my head around it any advice would be appreciated
Re: Not starting after changing emulsion tubes
Posted: Thu Jan 26, 2017 3:34 am
by Excalibre
Are the two vacuum hose connected correctly? One goes to the fuel tap and one to the fuel pump.
Check for kinked hoses too.
Pretty sure if you do a search there's a couple of threads covering what goes where.
Re: Not starting after changing emulsion tubes
Posted: Fri Jan 27, 2017 3:48 pm
by Crazluke
Yeah everything seems to be connected properly im just not getting fuel into the float bowls thetes no trapped or cinked tubes I cant understand why its not working
Re: Not starting after changing emulsion tubes
Posted: Sat Jan 28, 2017 5:55 am
by cobbadiggabuddyblooo
prime the carbies for 10 seconds using the prime (middle - horizontal) position on the fuel tap then back to on position...
If it starts and runs till the bowls are empty, just follow the trail back, Fuel in--kink in line , blockage in filter at carby attachment point ,vacuum lines correct to fuel pump and fuel tap from each inlet manifold stub. Fuel tank... prime again then try reserve.