Page 1 of 1
Inlets
Posted: Fri Jun 06, 2008 10:10 am
by Killerwhale
Hi!
Anyone got the vacuum (carb to head) inlets at hand (laying around) and can take an outer diameter measurement??
Cheers!!
Re: Inlets
Posted: Fri Jun 06, 2008 11:14 am
by youngy
you want the od of the casting where?
Re: Inlets
Posted: Fri Jun 06, 2008 2:50 pm
by Killerwhale
youngy wrote:you want the od of the casting where?
Actually it would be best on the most narrow part of it, tuner want´s to know how much it can be ported.
Re: Inlets
Posted: Fri Jun 06, 2008 2:57 pm
by youngy
as far as i can tell 46mm
Re: Inlets
Posted: Fri Jun 06, 2008 3:00 pm
by Killerwhale
youngy wrote:as far as i can tell 46mm
Cheers for that mate!!
