Page 1 of 3

bike is in for a dyno monday

Posted: Sat Jun 28, 2008 3:15 pm
by dillthedog
full akrapovic- fcr41,s every thing else standard
will post up results when i can

Re: bike is in for a dyno monday

Posted: Sat Jun 28, 2008 3:20 pm
by Killerwhale
dillthedog wrote:full akrapovic- fcr41,s every thing else standard
will post up results when i can
Do you have a before chart?

Re: bike is in for a dyno monday

Posted: Sat Jun 28, 2008 4:31 pm
by dillthedog
no unfortunatly not

Re: bike is in for a dyno monday

Posted: Sun Jun 29, 2008 10:53 am
by trixynut
OK, so lets play guess the bhp!!

Nearest one wins a goldfish in a bag.

I'lll go with ............ 88.

:D

Re: bike is in for a dyno monday

Posted: Sun Jun 29, 2008 11:15 am
by Killerwhale
trixynut wrote:OK, so lets play guess the bhp!!

Nearest one wins a goldfish in a bag.

I'lll go with ............ 88.

:D
Well, the setup should be good for ~10hp so my guess is 80hp at the rear wheel...89 at crank.

Re: bike is in for a dyno monday

Posted: Sun Jun 29, 2008 12:45 pm
by dillthedog
is that all :crybaby: :crybaby:

Re: bike is in for a dyno monday

Posted: Sun Jun 29, 2008 1:47 pm
by Killerwhale
dillthedog wrote:is that all :crybaby: :crybaby:
Ten HP on top on a TRX i think is a lot!!
...i would have tossed in a K&N also so it breathes all thru (you said all else was standard)

Re: bike is in for a dyno monday

Posted: Sun Jun 29, 2008 4:07 pm
by dillthedog
it has fcr,s with foam velocity stack filters

Re: bike is in for a dyno monday

Posted: Sun Jun 29, 2008 4:49 pm
by Killerwhale
dillthedog wrote:it has fcr,s with foam velocity stack filters
Heh, my bad....of cource you should take everything off the FCR´s!!

Re: bike is in for a dyno monday

Posted: Sun Jun 29, 2008 5:23 pm
by trixynut
Dyno will measure rear wheel hp. That set-up should add 10 over standard, so my guess is still ........ 88bhp which would be a very respectable increase over the standard 78bhp!

Re: bike is in for a dyno monday

Posted: Sun Jun 29, 2008 5:24 pm
by cheesie
89.2

Re: bike is in for a dyno monday

Posted: Sun Jun 29, 2008 6:40 pm
by Killerwhale
trixynut wrote:Dyno will measure rear wheel hp. That set-up should add 10 over standard, so my guess is still ........ 88bhp which would be a very respectable increase over the standard 78bhp!
Yeah, only thing is that TRX is 79 on the crank according to Yamaha´s "big book"...not rear wheel.

Re: bike is in for a dyno monday

Posted: Sun Jun 29, 2008 10:49 pm
by Kevtrx849
My guess would be 86 at the wheel. 8)

Re: bike is in for a dyno monday

Posted: Sun Jun 29, 2008 10:54 pm
by youngy
depending on the correction factor used it can read anything you like, but I'll got for 85 (as kev nicked the 86 I was going to have)

Re: bike is in for a dyno monday

Posted: Mon Jun 30, 2008 12:46 pm
by steve speed
86.7...........but i hope its more :D :D