Yamaha TRX850 Enthusiasts Forum

Posted: **Fri Jun 25, 2010 4:48 pm**

so been looking online and loads of diffrent seal drivers out there to choose from so which one and why?

or maybe none ive been told to use the old seal to drive it in with ?

http://cgi.ebay.co.uk/Honda-fork-oil-se ... 3a5c3f08e2
http://cgi.ebay.co.uk/Honda-CR-CRF-Yama ... 335e5e0b69
http://cgi.ebay.com/ebaymotors/MOTORCYC ... veQ5fTools
http://cgi.ebay.co.uk/LASER-4878-MOTORC ... 5ada5d4adf
http://cgi.ebay.co.uk/Fork-Seal-Driver- ... 3eeb37e134

I want to buy a tool for the job if its worthwhile im sure ill need to do otehr seals in future and the price of this tool is about an hours labour from most places it seems so suggestions please

Posted: **Fri Jun 25, 2010 7:08 pm**

I used the old seals to drive in the new....

Posted: **Fri Jun 25, 2010 8:00 pm**

Or a length of pipe?

Posted: **Fri Jun 25, 2010 9:40 pm**

seems to me a nice hard piece of nylon or similar type of pipe cut in half would do the trick well ? but where might i find some

Posted: **Sat Jun 26, 2010 6:57 am**

pwmotorsports wrote:seems to me a nice hard piece of nylon or similar type of pipe cut in half would do the trick well ? but where might i find some

What about some plumbing type pipe from a DIY shop?

Posted: **Tue Jul 06, 2010 5:26 pm**

well i used standerd white 40mm id sink pipe and cut a slot in it so it would give a little it did the job well enough

seal drivers ?