Yamaha TRX850 Enthusiasts Forum

Ok, after exhausting the search feature, does anyone have any info on this? I'm going digital speedo on the bike, Koso. Think its the RX2 or something. Anyway, its got a plug that goes into the water pipe (have to buy a little pipe with the fitting on it) but where in the system should I put it? Which pipe should I fit the water temp reader to?

Existing sensor is on the inlet (?) pipe on the top of the rad: there's a screw-in brass sensor.

Be best to put it in there, or wire it onto the existing sensor I'd have thought.

Wicked. Cheers. Be handy if they are the same thread. Thanks. Will look at the rad closer before I ask next time

If you lift the tank (two front bolts out, one either side, disconnect tap, loosen long bolt under seat and hinge it backwards) all will be revealed