Yamaha TRX850 Enthusiasts Forum

Hello,

I know that most bearings are sold in sizes and i have a brand new set of ZZR600 1998 rear wheel bearings, I was wanting to know if these would fit the TRX before i order a set of rear wheel bearings,if anyone knows?

Thanks

Off the top of my head I haven`t a clue.
Why don`t you simply take the rear wheel out and have a wee measure?
A steel rule is plenty accurate enough.
Ideally you want 2RS types, that simply means two rubber seals by the way. The black (sometimes blue or red too) rubber sections between the inner and outer steel surfaces of the bearing. They`re there to retain the grease inside the bearing.

Couldn't tell you, sorry.

I just took my old ones down to the bearing shop, $20 later it was sorted Always in stock, unlike my local Yamaha shop...

ok thanks, i can't get the rear wheel off just now, so ill figure something out