Page 1 of 1
Been on the Dyno today
Posted: Sat Oct 01, 2011 6:56 pm
by zednine
Popped over to Quill Exhausts today and tried my new motor on the dyno
Not too bad a result
Sorry about the quality of the pic but the original is on a PDF
Re: Been on the Dyno today
Posted: Sat Oct 01, 2011 7:11 pm
by Mincehead
Damn cannot view that from my work pc, what were your max bhp and torque figures zednine?
Re: Been on the Dyno today
Posted: Sat Oct 01, 2011 7:14 pm
by zednine
Hi Mince
i got 73.26 bhp @ 8650 rpm 50.51 ft/lb @ 6464 rpm
Re: Been on the Dyno today
Posted: Sat Oct 01, 2011 7:29 pm
by Mincehead
Not bad at all, I take it from those figures the motor`s virtually stock?
Re: Been on the Dyno today
Posted: Sat Oct 01, 2011 7:53 pm
by Mincehead
My old girls motor could do with a refresh now but she made 81 point something bhp and 62 point something (sorry, simply can`t remember the points) torque on a dyno at Stormin The Castle last September.
The inlet diameters have all been matched and she wears some FCR41`s with some very short carbon cans on the stock pipework but apart from that the motor`s stock.
