Page 1 of 1

My riding position

Posted: Sun Apr 19, 2009 3:55 pm
by trixynut
Just been fiddling with my riding position as I find the bike a bit uncomfy after about 45 mins riding, but don't want to compromise handling or ground clearance, so here's what I ended up with:

1. YZF dogbones, raising the rear 25-30mm
2. Forks through the yokes with 25mm (including fork top caps) showing
3. Bars raised up the forks 15mm with spacers
4. Double bubble screeen
5. 120/70 front tyre

This is giving me sharp steering, pleanty of ground clearance, not too much weight on the wrists, makes me sit in the middle of the seat, and not too much wind blast.

Raising the bars up the forks has made a massive difference to how in-control I feel and makes the whole front feel lighter.

Dave.

Re: My riding position

Posted: Sun Apr 19, 2009 7:23 pm
by steve speed
make it into a streetfighter you know you want to !!!!! :D :D :D

Re: My riding position

Posted: Sun Apr 19, 2009 11:34 pm
by trixynut
Nope, I don't.

:D

Re: My riding position

Posted: Mon Apr 20, 2009 10:10 am
by HolerTogni
Hi trixynut!
trixynut wrote: ...

1. (YZF dogbones,) raised(ing the) rear 25-30mm
(2. Forks through the yokes with 25mm (including fork top caps) showing)
3. Bars raised up the forks 15mm with spacers
4. Double bubble screeen - only on my race fairing and not ridden yet; but on May 01 I will :twisted:
5. 120/70 front tyre
...
That's quite like my riding position and I enjoy it very much - have fun!

Positioned greetings from Munich!

Re: My riding position

Posted: Mon Apr 20, 2009 12:28 pm
by phuk72
trixynut wrote:Nope, I don't.

:D
well said that man :wink:

Re: My riding position

Posted: Sun Aug 02, 2009 9:30 pm
by Jock414
But how tall are you in cm ,thanks !? :D

Re: My riding position

Posted: Sun Aug 02, 2009 10:01 pm
by trixynut
about 183cm? (6ft 1inch in english)

Re: My riding position

Posted: Mon Aug 03, 2009 9:53 pm
by Jock414
Amazing i am 183cm :D my forks are 30mm up but i dont have the dogbones i do have the
120-70.
I think i will try your settings !
Did you shift the clipons left to right upsidedown?

Re: My riding position

Posted: Mon Aug 03, 2009 10:25 pm
by trixynut
Didnt swap the clip-ons over as I dont like the angles in makes. Just slid them up the fork leg, then put in a spacer under the bolt that secures them to the yoke.

Re: My riding position

Posted: Tue Aug 04, 2009 8:48 am
by Silver
Mine is about the same, 12mm higher bars and same as yours on the fork tubes. No dog bones though but same front tyre. Managed 1750miles in a week this year, but sore arse is still a problem.

Re: My riding position

Posted: Tue Aug 04, 2009 11:37 am
by slow codger
:D Had the bars like that for ages, just got the dog bones on Sunday from Philk.
Re the seat there is no padding in it so it has the feeling of a plank of wood, get it recovered and put some more foam in it!

Dave E

Re: My riding position

Posted: Tue Aug 18, 2009 2:01 pm
by slow codger
:D Dogbones are on and been out for an hour and a half blast round the local back roads, The back end is higher yet I sit further back in the seat, how is that?? Handled well, however noticed a little muck flap on the rear of the standard mudguard now, that will be going!

Dave E

Re: My riding position

Posted: Wed Aug 19, 2009 12:27 am
by gregs656
the biggest comfort issue I have is the seat. I have read somewhere that cutting off that little tapered section helps, not tried it though.

My left shoulder is an issue after the accident, but that's more to do with the dog shite SV hire bike than the TRX, so I can't really hold it against it.