Yamaha TRX850 Enthusiasts Forum

Alright team does anyone know what thread I would need for a hydraulic switch for a 1998 TRX Brembo written on it?
Trying to get a hydraulic switch like the one Mincehead mentioned in the Harris Rearset topic for me...

http://cgi.ebay.co.uk/LINE-BRAKE-LIGHT- ... 3cb4b98168

Thanks in advance...

In my last link on my last post it was at the bottom of the page, Brembo`s are M10 x 1.00 thread / pitch Red Baron, but to be SURE give a bike spares shop a ring to confirm it if you`ve found a shop that stocks them.
Ferk I`m good to you lot:

http://cgi.ebay.co.uk/YAMAHA-BRAKE-LIGH ... 4143125ce9

Cheers Mincey
Thats the drama finding a shop that has one. I sent a few email enquiries out to 3 overseas places to see if they know. Thought it would be easier confirming exactly what thread I need then I don't need a specific trx one, especially after what Trixynut said...
your such a legend big fella

Try GB Moto - very helpful & have their own range of switches for around £15 & loads of other nice stuff!

You been affected by the winds Vic?

Cheers, no winds this way, little bit of rain, the edge of the wind is about 1000km away.
Had some mates in the middle of it drive of at least 7 hours to evacuate.