Front Fork Specs

Moderators: trixynut, Mincehead, dicky, phuk72, Jak, Kevtrx849

Post Reply
User avatar
Wally
TRX-Enthusiast
Posts: 277
Joined: Fri Oct 07, 2011 8:34 am
Location: Sydney
Contact:

Front Fork Specs

Post by Wally » Thu Feb 19, 2015 9:28 pm

Hi
I want to get my front fork tubes whats the specs on these for rechrome??
Thanks

User avatar
Wally
TRX-Enthusiast
Posts: 277
Joined: Fri Oct 07, 2011 8:34 am
Location: Sydney
Contact:

Re: Front Fork Specs

Post by Wally » Sat Feb 21, 2015 4:14 am

Can & how do you remove the internal bush at the bottom of the fork leg??

User avatar
Wally
TRX-Enthusiast
Posts: 277
Joined: Fri Oct 07, 2011 8:34 am
Location: Sydney
Contact:

Re: Front Fork Specs

Post by Wally » Sun Feb 22, 2015 5:59 am

This bush ,,how to get it out???

User avatar
Con Rod
Site Sponsor
Posts: 1126
Joined: Wed Nov 16, 2011 11:48 pm
Location: Sydney, Australia

Re: Front Fork Specs

Post by Con Rod » Sun Feb 22, 2015 6:32 am

i would like to help, but not really sure what it is you want to know from the question,

Can you elaborate?
Paul

User avatar
Wally
TRX-Enthusiast
Posts: 277
Joined: Fri Oct 07, 2011 8:34 am
Location: Sydney
Contact:

Re: Front Fork Specs

Post by Wally » Sun Feb 22, 2015 6:46 am

sorry didn't ad pic
You do not have the required permissions to view the files attached to this post.

User avatar
M.V.
Site Sponsor
Posts: 1509
Joined: Sat Jul 04, 2009 3:23 am
Location: Melbourne, Australia

Re: Front Fork Specs

Post by M.V. » Mon Feb 23, 2015 11:26 pm

Is that the upper or lower Wally?

User avatar
Wally
TRX-Enthusiast
Posts: 277
Joined: Fri Oct 07, 2011 8:34 am
Location: Sydney
Contact:

Re: Front Fork Specs

Post by Wally » Mon Feb 23, 2015 11:46 pm

lower leg its were the small white bush slides in
If you stick your finger in the inner sl
eve will rotate
These componets are not shown on the parts list at all

User avatar
M.V.
Site Sponsor
Posts: 1509
Joined: Sat Jul 04, 2009 3:23 am
Location: Melbourne, Australia

Re: Front Fork Specs

Post by M.V. » Wed Feb 25, 2015 1:33 am

Stretching the memory a little, but I think as long as the stanchion is out, you shouldn't need to go any further. There is a slider in there I think, copper, with a coating on it that may need to be replaced, but I think that just slides out, perhaps with a wire clip above... It's been a long time since I had the forks apart!

Post Reply