Problem on quick throttle openings/Low RPM

[M.V.]

Ok, so I've got some results, I set the float heights PROPERLY, dropped the needle down, & fine tuned the idle jet screw to 1 turn out (I didn't want to go any leaner...), it's ridable now.

New emulsion tubes & a Factoy Pro Jet kit should be here next week, hopefully that should sort everything out!

It's still a bit of pig own low, but a bit of clutch slip & a lot of revs sorts that out.

[HansJ]

Also check the diaphragms, there might be a tiny hole in them.

[M.V.]

Thanks for the input, all the diaphragms, seals & vacuum lines appear to be intact.

When I get the Emulsion tubes, I will tune her up, balance the carbs & report back! I suspect the E tubes will fix all of my (bike ) problems!

Thanks everyone for the help & feedback, much appreciated!