U got 16/40 and paid attention?

Killerwhale · Post by **Killerwhale** » Sat Oct 17, 2009 7:51 pm

Well, i run 16/40 now and think itÂ´s a bit slow...and revs like Â´ell
70 front wich makes the speedo somewhat unreliable, 180/55 rear...
9000rpm in 2nd & 3rd gear is 120 & 160km/h on the speedo, guess itÂ´s a bit higher due to the front...

Anyone with same setup that has checked this out?

cobbadiggabuddyblooo · Post by **cobbadiggabuddyblooo** » Sun Oct 18, 2009 8:30 am

Running the 16/40 gearing with std 60 profile and front and rear and 160 rear as such so can give you an idea over the next couple of days when I sneak out for a fang...

ekoja · Post by **ekoja** » Mon Oct 19, 2009 11:43 pm

I run 16/41 which I though was going to give better acceleration, but in fact it turned out to be,( according to the calculators) only about 2kmh different at, if I remember rightly, 4000 revs

Stu99 · Post by **Stu99** » Wed Oct 21, 2009 12:59 pm

I run 16/41 and find it good, but it is street riding more than motorway. I want all my fun in the 0-120. You will have to re-calculate for the 180/55. I'm sure someone here will have a formula for that so you can compare.

cobbadiggabuddyblooo · Post by **cobbadiggabuddyblooo** » Thu Oct 22, 2009 11:20 pm

Damm didn't quite get the result you wanted in secong gear

..mmmmm got 6mths and $850...

Just as well I didn't pick third gear it would have been worse

But yes from memory pretty sure 160k's is 9000rpm in 3rd...

cobbadiggabuddyblooo · Post by **cobbadiggabuddyblooo** » Wed Oct 28, 2009 12:26 pm

yes can confirm 120kph 9000rpm 2nd gear 160kph 3rd 9000rpm with std 60 profile tyres and 15/40 gearing....

who me no officer i wasn't riding

Killerwhale · Post by **Killerwhale** » Wed Oct 28, 2009 1:08 pm

cobbadiggabuddyblooo wrote:yes can confirm 120kph 9000rpm 2nd gear 160kph 3rd 9000rpm with std 60 profile tyres and 15/40 gearing.... who me no officer i wasn't riding

So one can say that a 70 profile front is one tooth on the front sprocket

Tarwetijger · Post by **Tarwetijger** » Wed Oct 28, 2009 2:14 pm

Killerwhale wrote:8<
70 front wich makes the speedo somewhat unreliable

I wouldn't worry about that to much. I checked the speedo with GPS and it appeared to be quite accurate! I have a 70 front too.

Killerwhale wrote: So one can say that a 70 profile front is one tooth on the front sprocket

Somehow that sounds a little bit too short!

cobbadiggabuddyblooo · Post by **cobbadiggabuddyblooo** » Wed Oct 28, 2009 11:05 pm

my mistake lookin over my shoulder incase I was followed..

I mean 16 tooth front

cobbadiggabuddyblooo · Post by **cobbadiggabuddyblooo** » Thu Oct 29, 2009 2:49 am

ok I admit my typing skills arn't the best

so you won't find me in high heels and a skirt sitting behind a desk

or auditioning for the next production of rocky horror for that matter

Yamaha TRX850 Enthusiasts Forum

U got 16/40 and paid attention?

U got 16/40 and paid attention?

Re: U got 16/40 and paid attention?

Re: U got 16/40 and paid attention?

Re: U got 16/40 and paid attention?

Re: U got 16/40 and paid attention?

Re: U got 16/40 and paid attention?

Re: U got 16/40 and paid attention?

Re: U got 16/40 and paid attention?

Re: U got 16/40 and paid attention?

Re: U got 16/40 and paid attention?