For some reason I have been saving bikeparts for a while, I just found a pile of dogbones in my garage. I would like to experiment with it a bit, but what are the dimensions of the original TRX dogbones? Could that be 179 mm?
I happen to have 172 mm, 169 mm and 182 mm. The last one would actually lower the rear, right?
Dogbone measurements
Moderators: trixynut, Mincehead, dicky, phuk72, Jak, Kevtrx849
-
Tarwetijger
- TRX-Enthusiast
- Posts: 1524
- Joined: Tue May 15, 2007 9:31 am
- Location: Netherlands, Assen
- Contact:
-
bobtrx
- Site Sponsor
- Posts: 477
- Joined: Fri Jan 07, 2005 11:07 am
- Location: aust vic country
Re: Dogbone measurements
My standard dog bones are 182mm . From memory I made a set with hole centres 6 - 8 mm less ( 174 mm ) that gave a rear end lift of about 30mm .
catch ewe later bob
-
trixynut
- Site Sponsor
- Posts: 2572
- Joined: Fri Sep 22, 2006 3:48 pm
- Location: Leicester, England
Re: Dogbone measurements
Shorter = higher.
-
Tarwetijger
- TRX-Enthusiast
- Posts: 1524
- Joined: Tue May 15, 2007 9:31 am
- Location: Netherlands, Assen
- Contact:
Re: Dogbone measurements
Okay, I'll try 172 mm then. Cheers.