Well Ive got my crank back from the reconditioner and ready to reassemble
What sealant do you reccomend for the crankcase joint ?
Can I use a silicone or should I wait till next week and get some Yamaha stuff ?
Chris
Crankcase joint
Moderators: trixynut, Mincehead, dicky, phuk72, Jak, Kevtrx849
-
zednine
- Site Sponsor
- Posts: 306
- Joined: Sat Oct 23, 2010 8:50 pm
- Location: Oswaldtwistle
-
Smithers
- TRX-Enthusiast
- Posts: 62
- Joined: Fri Jan 15, 2010 2:06 pm
- Location: Tauranga, New Zealand
Re: Crankcase joint
Silicon is fine .... I take it you refer to the orange or black stuff that takes a bit of heat and is meant for gaskets
-
Marty Moose
- TRX-Enthusiast
- Posts: 58
- Joined: Sat Apr 09, 2011 1:01 am
- Location: Western Australia
Re: Crankcase joint
You want three bond.
MM
MM
-
zednine
- Site Sponsor
- Posts: 306
- Joined: Sat Oct 23, 2010 8:50 pm
- Location: Oswaldtwistle
Re: Crankcase joint
Smithers wrote:Silicon is fine .... I take it you refer to the orange or black stuff that takes a bit of heat and is meant for gaskets
Thanks Smithers ........... ive got some orange in stock
-
zednine
- Site Sponsor
- Posts: 306
- Joined: Sat Oct 23, 2010 8:50 pm
- Location: Oswaldtwistle
Re: Crankcase joint
What is that then please .........readily available ?Marty Moose wrote:You want three bond.
MM
-
Marty Moose
- TRX-Enthusiast
- Posts: 58
- Joined: Sat Apr 09, 2011 1:01 am
- Location: Western Australia
Re: Crankcase joint
Its what most factories use on cases.
