Grubby oil sight glass

Moderators: trixynut, Mincehead, dicky, phuk72, Jak, Kevtrx849

Post Reply
User avatar
Wombat
Forum Marsupial
Posts: 1092
Joined: Fri Jan 07, 2005 10:50 am
Location: Carlingford, Sydney, Australia

Grubby oil sight glass

Post by Wombat » Tue Nov 27, 2012 8:16 am

Oil is a bit above 6,000km old and the bike has started to use a bit. Is sitting just below the Full mark but have noticed an oily residue on the inner pane of the sight glass that doesn't move when the motor is started (the oil level does move as per normal). Bike seems to be running quite normal. Is it some form of condensation? Or just worn out oil. Weather here is very warm (30deg +) but very humid. Daily commute is 25km each way. P.ersonal thoughts are new oil and a VERY long run to clear the motor. Gonna pop in and see my mechanic on the way home and get his opinion.

Bob
"The fire is almost out......and there's nothing left to burn!"

User avatar
Mincehead
TRX-Enthusiast
Posts: 6345
Joined: Sun Jan 25, 2009 1:40 pm
Location: West Sussex
Contact:

Re: Grubby oil sight glass

Post by Mincehead » Tue Nov 27, 2012 9:56 pm

If she`s using a bit it could well be `blow by` past the rings Bob, that would also be giving you the carbon in the oil that`s settling on the sight glass. :wink:
LOUD PIPES SAVE LIVES

User avatar
Wombat
Forum Marsupial
Posts: 1092
Joined: Fri Jan 07, 2005 10:50 am
Location: Carlingford, Sydney, Australia

Re: Grubby oil sight glass

Post by Wombat » Wed Nov 28, 2012 5:53 am

Could be Mince, she's done 107,000kms.
Still running ok, though.
Popped into my mechanics this afternoon and he had a look and said it was fine. He'd seen ones worse than that.

Bob
"The fire is almost out......and there's nothing left to burn!"

User avatar
Rod.s
Site Sponsor
Posts: 1404
Joined: Sun Apr 25, 2010 11:01 am
Location: Brisbane, Australia

Re: Grubby oil sight glass

Post by Rod.s » Wed Nov 28, 2012 6:39 am

Wombat wrote:Could be Mince, she's done 107,000kms.
Still running ok, though.
Popped into my mechanics this afternoon and he had a look and said it was fine. He'd seen ones worse than that.

Bob
You could always do a oil flush and clean, this will remove any crap/carbon/children from the engine. :D
If it's not made in China, it's a fake!

User avatar
nastybud
TRX-Enthusiast
Posts: 26
Joined: Thu Feb 14, 2013 9:11 pm
Location: west sussex uk

Re: Grubby oil sight glass

Post by nastybud » Wed Feb 27, 2013 10:30 pm

Wombat wrote:Oil is a bit above 6,000km old and the bike has started to use a bit. Is sitting just below the Full mark but have noticed an oily residue on the inner pane of the sight glass that doesn't move when the motor is started (the oil level does move as per normal). Bike seems to be running quite normal. Is it some form of condensation? Or just worn out oil. Weather here is very warm (30deg +) but very humid. Daily commute is 25km each way. P.ersonal thoughts are new oil and a VERY long run to clear the motor. Gonna pop in and see my mechanic on the way home and get his opinion.

Bob
just a thught i have had a simuler issuse on my previuse suzuki bandit 400v if it is a sort of cream or has a hint of white to it.
it can be discharge from a hot or burning clucht. if you take the engine casing off around the clutch and find more of it then there is you problem.
hope this helps
Work - Eat - Sleep
Weekend Find The Oil! :D

Post Reply